10AN Push in Fitting for Factory GM LS Valve cover grommet Motion SXS

10AN Push in Fitting for Factory GM LS Valve cover grommet Motion SXS10AN Push in Fitting for Factory GM LS Valve cover grommet Motion Raceworks This billet aluminum fitting presses into the driver side rear valve cover grommet on Gen 3 and 4 LS engines to adapt to 10AN for easy connection of PCV systems. Made in the USA Includes grommet for use if not using in intended valve cover use

this can not only flows a high amount of air but keeps the filter and your engine bay dry from oil saturation due as commonly seen on other catch cans and non baffled catch cans

We have found that this offers more than adequate true oil capacity for traditional racing use

turbochargers

This will result in the same high performance baffled catch can attributes but with larger capacity

Includes 6 feet of line so that you can mount your catch can virtually anywhere in any engine bay and have enough line

Mounting Bracket w/ Hardware

Actual weight is 18lbs

and with supercharged vehicles you often need to move the filter element away from areas where belt slippage can happen from very small invisible particulate that occurs

These are 3 bolt flange bolt style made out of

Drainback: Run fluid to bottom of can

These are billet aluminum clamp on mounts for hood pins

Saves 6lbs