7’1” Jive Space Elevator face

7’1” Jive Space Elevator face8'1" x 21 1 2" x 2 15 16" Jacob Ells is a Santa Barbara based shaper who is always looking to push the boundaries of alternative boards. The Space Elevator model was made to trim with long parallel foiled rails, pulled in nose, and rounded tail. The rocker of the board is low allowing for high down the line speed. The bottom contour is quite interesting starting flat in the nose and quickly turning into a tri plane hull with a deep single concave that

meditation

A moderate nose concave gives her more stability on the nose

We have this one available for members of our Research Center to test out here

The rail foil starts turned up in the nose

Moss & Coastal Redwood

but has a continuous curve with a bit of flip in the nose

and trustworthy

the lower volume version yields itself plenty of glide and allows the more "shreddy" personality of the model to shine

Paul's Round Pin Log rides the line between a very comfortable noserider and a loose

but tap into a whole other realm of speed and flow

The rocker is minimal which allows for increased trim speed

effortless glide