8MM 33 Tooth Top Pulley For PSI Superchargers Engine Internal

8MM 33 Tooth Top Pulley For PSI Superchargers Engine Internal8mm 33 tooth Top Pulley for a PSI supercharger is made using 7075 T6 Aircraft Quality Aluminum. They pulleys incorporate extra material for added strength and have a small radius in the back to accomodate our stronger snout for the PSI blower. They are 3. 750" (95mm) long for use with either a 75mm or 84mm wide blower belt.

reduced flexing

Ignition data acquisition accepts multiple runs

This Dual Idler Assembly is designed to reduce the oscillation of the belt on the tension side allowing improved contact wrap with the drive pulley

Shift light settings for each gear

This tool allows you to accurately check enlargement in the retainer taper when servicing cylinder heads and sets a standard when retainers need replacement helping to prevent failure

that there is over 40 feet of conductor wrapped into a single foot of plug wire

**Pulleys are 3

The Power Grid Controller is supplied with the View Software

no need to login into software

(1) 1/4" Dowel Hole

and is USB compatible

Four steps of rpm limits for burnout