Ripper - Brushed Gold Fender Basses

Ripper - Brushed Gold Fender BassesPlease note that this pickguard will only fit genuine 1973 1983 Gibson Ripper basses. The earliest Gibson Ripper basses (1973 1975) do not have pickup mounting holes. This pickguard will not fit an Epiphone manufactured instrument even it does have the Gibson name on the truss rod cover. Made from black plastic with a very thin layer of simulated brushed gold on top. 2. 28mm thick (. 090") with a 45 degree outer bevelled edge. Close up side view

Height at highest point- 8mm

The amps therefore became much bigger and much louder

A set of 6 slotted solid brass bridge pins with no decorative dot

Comes complete with 2 fixing nuts and washer

Specification (inches):

The red reflective layer is attached to the underside of the acrylic

Zinc baseplate with brass saddles for added chime

Gibson Explorer

393 N/A Approx In 2 29/32 3/32 3/8 N/A Millimeters

Getting the bridge to return to the same position after use was a different problem all together

This is a true custom shop quality "tonewood" guitar body and is ideal for anyone wishing to build themselves a high-end guitar

Push-in tremolo arm for the tremolo system used on Fender Jaguar and Jazzmaster guitars